Commercial and industrial only, no residential Dallas and Fort Worth 24/7 emergency dispatch 469-423-6724

Rooftop Equipment

Rooftop Unit Repair in Dallas and DFW

Package rooftop units carry most of the conditioning load for retail strips, office parks, and warehouses across DFW, and they take weather that indoor equipment never sees. We service package RTUs from 3 to 50 tons, working through compressor faults, economizer failures, and stuck actuators without pulling the unit off the curb unless replacement is the right call.

  • Same-day and next-day service calls
  • Chiller plants up to 500 tons
  • All major brands
Open access panel on a commercial package rooftop unit showing the compressor section
Rooftop units 3 to 50 tons
Chillers air and water cooled
Boilers and heating gas and hydronic
Controls BAS, VAV, sensors

What's covered

Compressor diagnostics and repair

Amp draw and pressure testing to determine whether a compressor is failing mechanically or being starved by another fault.

Economizer and damper repair

Fixing stuck or miscalibrated economizer dampers that waste energy or let unconditioned air into the space.

Actuator replacement

Replacing failed damper and valve actuators that stop the unit from modulating outdoor air properly.

Belt-drive blower service

Adjusting or replacing belts, pulleys, and bearings on blower assemblies to restore correct airflow.

Gas ignition and burner checks

Servicing the gas heat section of dual-fuel and gas-electric package units, including ignitors and flame sensors.

Common symptoms

Facilities usually call about one or more of the following before a tech is ever dispatched.

  • Unit cycles the compressor on and off in rapid succession
  • Economizer damper stuck fully open even when outdoor air is too hot to use
  • Rattling or grinding noise from inside the cabinet on startup
  • Roof curb showing signs of water intrusion around the unit base
  • Airflow noticeably weaker at diffusers than it used to be
  • Unit trips on high pressure during the hottest part of the afternoon
  • Gas heat section fails to ignite on the first several attempts

How the visit works

  1. 1
    Rooftop inspection

    We access the unit, check the curb and cabinet condition, and pull panels to inspect the compressor, economizer, and blower sections.

  2. 2
    Component testing

    Actuators, contactors, and pressure switches are tested individually to find the specific part causing the fault.

  3. 3
    Repair or advise replace

    If the unit is repairable, we complete the fix on site. If age and repair cost point toward replacement, we walk through that option honestly.

  4. 4
    System verification

    The unit runs a full cooling and heating cycle before we consider the call complete.

Equipment we service

Our techs carry diagnostic tools for equipment across manufacturers rather than specializing in one brand. Equipment we service includes:

CarrierTraneLennoxYorkAAONRheem

Available across Dallas and Fort Worth

This service runs on the same routes as the rest of our work, across the following areas.

View all service areas

Common questions

What size rooftop units do you service?

We work on package RTUs from roughly 3 tons up to 50 tons, covering the range typical of retail, office, and light industrial buildings.

Can you fix an economizer that will not close?

Yes, stuck economizer dampers usually trace to a failed actuator or a linkage that has come loose, both of which we repair on site.

Do you handle the gas heat side of package units, not just cooling?

Yes, our techs check ignitors, flame sensors, and heat exchangers on gas-electric and dual-fuel rooftop units during the same visit.

Is it ever better to replace a rooftop unit than repair it?

Sometimes. When a compressor or heat exchanger fails on an older unit, replacement can make more sense, and we will tell you honestly which way the numbers point.

Tell us about the equipment and the symptom, and we will get a technician scheduled.

Request commercial HVAC service

Prefer to talk it through? Call 469-423-6724.

Call 469-423-6724 Request service