Heating & Boilers
Commercial Heating and Boiler Repair in Dallas
Gas heat gets little attention in a city that runs cooling most of the year, until the first cold snap exposes a pilot that will not hold or a heat exchanger with a crack in it. We repair gas-fired boilers and hot-water heating loops for buildings that need reliable heat on the handful of days DFW actually demands it.
- Same-day and next-day service calls
- Chiller plants up to 500 tons
- All major brands
What's covered
Boiler ignition and pilot repair
Servicing pilot assemblies, ignitors, and flame sensors that keep a boiler from lighting or from staying lit.
Heat exchanger inspection
Checking for cracks and corrosion that can allow combustion gases to enter the airstream, a safety issue as much as a comfort one.
Hot-water loop diagnostics
Tracing circulation problems, air-bound piping, and pump faults that leave parts of a building cold while others overheat.
Combustion and flue analysis
Testing combustion efficiency and flue draft to confirm the boiler is burning gas cleanly and venting properly.
Control and aquastat repair
Fixing failed aquastats and boiler controls that mis-fire the heating cycle or run the loop at the wrong temperature.
Common symptoms
Facilities usually call about one or more of the following before a tech is ever dispatched.
- Pilot light will not stay lit after multiple relight attempts
- Boiler short cycles on and off within a few minutes
- Some zones of the building run cold while others overheat
- Popping or rumbling noise from the boiler during a heating cycle
- Soot or discoloration visible around the flue connection
- Circulator pump running but radiators or unit heaters stay cool
How the visit works
- 1 Safety check first
Before any repair, we check for gas leaks, flue draft problems, and heat exchanger integrity, since heating equipment carries combustion risk.
- 2 Ignition and control diagnostics
We test the pilot, ignitor, flame sensor, and aquastat to find what is preventing a clean, sustained heating cycle.
- 3 Loop-side troubleshooting
Circulator pumps, zone valves, and piping are checked when the boiler fires correctly but heat is not reaching all zones.
- 4 Combustion verification
A combustion analyzer confirms the burner is operating within safe and efficient parameters before the call is closed.
Equipment we service
Our techs carry diagnostic tools for equipment across manufacturers rather than specializing in one brand. Equipment we service includes:
Related services
Commercial HVAC repair
Facility managers call us when a unit stops cooling, stops heating, or trips a breaker and nobody on staff can tell why.
Maintenance AgreementsPreventive maintenance
Most commercial breakdowns trace back to something a scheduled visit would have caught: a clogged drain pan, a slipping belt, a coil packed with debris.
Emergency ServiceEmergency repair
A conditioning failure at a data closet, a medical clinic, or a full retail floor does not wait for regular business hours, so we run 24/7 emergency dispatch for exactly those calls.
Available across Dallas and Fort Worth
This service runs on the same routes as the rest of our work, across the following areas.
Common questions
Is it dangerous if my boiler's pilot keeps going out?
It can indicate a flame sensor, thermocouple, or draft problem, and repeated relighting without diagnosing the cause is not something we recommend.
Why is one part of my building cold while the rest is fine?
That pattern usually points to a zone valve, circulator pump, or air-bound section of the hot-water loop rather than the boiler itself.
Do you check for carbon monoxide risk during a heating repair?
Yes, heat exchanger and flue inspection are part of every boiler service call, since a cracked exchanger is a safety issue first.
How often does commercial heating equipment need attention in Dallas?
Less often than in colder climates, but that also means problems get discovered late. A pre-season check before the first cold snap catches most of them early.
Tell us about the equipment and the symptom, and we will get a technician scheduled.